Options
canon 450D/xsi soft focus? help
I just started to use my canon 450D again and noticed that autofocus is off. I think it sa actually front focusing.
I am 99.9% sure that this is a camera problem since I used a number of lenses with this and my canon 7D :scratch
I am 99.9% sure that this is a camera problem since I used a number of lenses with this and my canon 7D :scratch
Canon 7D, 450D, 50mm 1.8, 50mm 1.2, Mp-e 65mm, 70-200mm f/2.8L USM, 17-55mm f/2.8 IS USM, Canon 100mm f/2.8L macro IS USM, 580exII, some sigma lenses:D
0
Comments
1) Basic AF accuracy is best accomplished using a flat target, i.e. a brick wall or other large textured surface. If a camera/lens cannot accomplish this task, it has no chance of passing any subsequent AF tests including real world use. Make sure that the target is at the typical distance for your normal use of the lens, meaning that a long focal length lens that you would normally use for wildlife at a distance should be tested at that same distance for AF accuracy. Always test a lens at least twice Minimum-Focus-Distance (MFD). Lenses rarely do their best at MFD (the exception being true "macro" lenses.)
If a lens shows consistent front or back focusing with the wall test, then use micro-focus adjust technique until you get consistent accuracy. If the particular camera body does not have a micro-focus option, it should be serviced, or the lens should be serviced. If you have consistent results with all lenses then send in the camera. If the problem only exists with a particular lens, it's the lens that needs service.
If the lens passes the wall test, proceed to the next test. If the lens fails the wall test and you cannot gain accurate AF with micro-adjust, send the lens back to where it came from or explore camera issues.
2) A fence line or similar, shot at an angle to the subject. Put a singular strong-contrast target on the top of the middle post and use a single focus point in the camera to focus against the target. This shows focus accuracy and/or how easily distracting for/aft objects influence AF accuracy (compared to the above wall shot). It also shows bokeh tendencies at different aperture settings.
3) A focus target/chart like in the following:
http://regex.info/blog/photo-tech/focus-chart
I do recommend testing these charts at twice minimum focus distance or greater. Most lenses, especially most zoom lenses, do not do their best at MFD. True macro lenses are the major exception.
4) A US stop sign, or similar very high contrast signage, both centered and off center and to the side and/or corner. This can show chromatic errors and off-axis errors.
5) A spectral highlight at night. (Point source ideally, but a street light at some distance will do.) Try to avoid "blooming" of the source but allow some white clipping. This shows internal reflections and dispersion problems. Again, test both in the center and with the subject at the sides or corners.
6) Now just shoot "typical" subjects for your use of the lens(es). It's important that the lens perform correctly for your intended uses.
Moderator of the Cameras and Accessories forums
I tried it out and it can't pass the first one
Moderator of the Cameras and Accessories forums
Thank you for all the help