CS3 bridge question.

davev

I have made a few workspaces to view my shots, but every time I re-open the program, it goes to a default workspace that was programed in at the factory.

Is there a way to make one my workspaces the default workspace?

I'm sure this is in the manual somewhere, but I'm not sure what I did with my manual.

BTW, I'm using a Mac.

Thanks in advance.

jfriend

davev wrote:

I have made a few workspaces to view my shots, but every time I re-open the program, it goes to a default workspace that was programed in at the factory.

Is there a way to make one my workspaces the default workspace?

I'm sure this is in the manual somewhere, but I'm not sure what I did with my manual.

BTW, I'm using a Mac.

Thanks in advance.

My Bridge CS3 starts up in the last workspace I was using.

davev

jfriend wrote:

My Bridge CS3 starts up in the last workspace I was using.

Mine doesn't. It always goes back to the default screen.

gluwater

davev wrote:

Mine doesn't. It always goes back to the default screen.

It does that cause you shoot jpg :hide

I checked and cannot find any options to change the default settings. But if you save your layout how you like it you can change the shortcut key in the bottom right of the screen, the 1, 2, and 3 buttons, by clicking on one and holding the mouse button. The different layouts will pop up and you can select the layout you want for that button. It's not a fix but it's a little quicker than going to the menu bar each time.

gus

jfriend wrote:

My Bridge CS3 starts up in the last workspace I was using.

So does mine.

Pezpix

I dont know if this plays into your workflow question Dave, but my Bridge CS3 opens to the last state I had it in WITH the exception of when I am working from an external hard drive and then forget to power it back up before opening bridge.