Portable flash and studio

karuzo · January 29, 2006

Hello,
I am thinking in getting into studio photography. I have (2) portable flash units. Using KM 7D I have a 5600HS and another brand I use with another camera. How can I trigger the 5600HS wirelessly without using the built in flash? Is there a cable to connect between the camera and the flash unit? Also, the other flash I have cannot be triggered wirelessly. Any accessory that will allow it to act as a slave? Last, How do they mount on a tripod and how umbrellas mount to them (or the tripods)? I have not recearched this yet hoping someone who did, can give me a quick hint.

pathfinder · January 29, 2006

You have not specified a budget. IF your flash and camera can accept PC cords that is the cheapest by far.

But far better is a set of Pocket Wizards - a radio transmitter that mounts on the hot shoe of your KM 7D and a receiver that connects to your flash via a short PC cord. These are reliable and do not leave you with cords for someone to trip over or pull over your camera and tripod.

http://www.bhphotovideo.com/bnh/controller/home?O=productlist&A=details&Q=&sku=168584&is=REG&addedTroughType=categoryNavigation

Many electronic flash shoes have a 1/4 x 20 or a 3/8 thread that fits right on a tripod thread. If they are being fired by a Pocket Wizard they can just be taped into place too.

karuzo · January 30, 2006

Thanks. I was aware of pocket wizards and even used them once. It is the expensive route I am trying to avoid. A pc socket would be the best choice so far as you mentioned. What about the other brand flash I have - How can I trigger that one w/o a wizard. I do not think this one come with a thread to fit on a tripod. Last, how can I accomodate a flahs with an umbrella?

pathfinder wrote:

You have not specified a budget. IF your flash and camera can accept PC cords that is the cheapest by far.

But far better is a set of Pocket Wizards - a radio transmitter that mounts on the hot shoe of your KM 7D and a receiver that connects to your flash via a short PC cord. These are reliable and do not leave you with cords for someone to trip over or pull over your camera and tripod.

http://www.bhphotovideo.com/bnh/controller/home?O=productlist&A=details&Q=&sku=168584&is=REG&addedTroughType=categoryNavigation

Many electronic flash shoes have a 1/4 x 20 or a 3/8 thread that fits right on a tripod thread. If they are being fired by a Pocket Wizard they can just be taped into place too.

USAIR · January 30, 2006

Make sure you look here to...some good info

Fred

karuzo · January 30, 2006

Great info.
Thanks,

USAIR wrote:

Make sure you look here to...some good info

Fred

Portable flash and studio

Comments